The Analogue module provides the capability to monitor, report and action on analogue quantities within a Concept 4000 system.

This module can be programmed to operate an auxiliary when an analogue level from one or more of it's independent analogue inputs exceeds or goes below a pre-programmed trigger point.

Analogue levels can be monitored and/or controlled in scaled units at any LCD Terminal or remotely off-site.

Flexible Programming Options

The Analogue Module allows the programmer a variety of selectable mode settings and levels with which to configure the system to the particular application. Trigger point, output auxiliary, tamper levels and hysteresis values may be individually selected for each input.

Features:

• Four independent analogue inputs, each with it's own programmable 'trigger point'
• 0-5V or 4-20mA types available
• 8 bit resolution, 1% accuracy
• Compatible with the Serial Temperature Sensor (995089)
• LAN voltage monitoring
• Cabinet tamper input
• Four output auxiliaries
• Two general purpose digital inputs (No EOL resistors)

Download data sheet

Physical
Cabinet Dimensions	305(L) x 140(W) x 72(D) (mm)
PCB Dimensions	140(L) x 95(W) (mm)
Installation Environment	0°C - 40°C @15 - 85% Relative humidity (non-condensing)
Electrical
Input Voltage to PCB	11-14VDC
Operational Current	~30mA
Inputs
Zone Inputs	4 Analogue inputs, 2 general purpose Zone Inputs
Input Range: Voltage Option	0-5VDC uni-polar referenced to 0V input terminal
Input Range: Current Loop Option	4-20mA DC polarised, input termination resistor selectable
Input Impedance	10kOhm set by input termination resistor. (ADC Input Impedance ~ 10MOhm)
ADC Resolution	8bit
Input Resolution	20mV
Over Voltage Protection	Yes
ESD Protection	Yes
Outputs
Outputs (open collector)	4
Max. Switchable Current per Auxiliary	200mA
Max. Combined Output Current	To be included within the constraints of the power supply source